transparent logo.png
  • HOME

  • ABOUT US

  • PRODUCTS & SERVICES

  • DOWNLOADS

  • TESTIMONIALS

  • CONTACT

  • SHOP

  • NEWS

  • Forum

  • Members

  • More

    Use tab to navigate through the menu items.
    0
    To see this working, head to your live site.
    • All Posts
    • My Posts
    Droseph Dang
    May 14, 2021

    Printing settings

    in General Discussions

    Hello I am new to 3D printing and I am using a elegoo Mars 2 and my question is what is the recommended print settings for this resin?

    thank you!!!

    4 comments
    0
    Pengcheng Lv
    May 14, 2021

    Below are the BASELINE parameters for the ELEGOO MARS 2 printer:

    Layer thickness: 0.05 mm

    Number of bottom layer: 10

    Bottom layer exposure time: 45 seconds

    Normal layer exposure time: 5 seconds

    Bottom light-off delay: 4 seconds

    Normal light-off delay: 2 seconds

    Every other parameters should be kept as the manufacturer default values.

    0
    Pengcheng Lv
    May 14, 2021

    ELEGOO MARS 2 is a newer printer with a much higher UV power, which is similar to the Anycubic Photon Mono printer. Therefore, the settings for older version of LCD printers with lower UV flux can be applied here. Otherwise, unnecessarily long exposure can lead to a substantial amount of heat deposited onto the build plate, thus causing the wax content in the resin to melt, which would weaken the adhesion between the photopolymer and the buildplate to cause the adhesion issue.

    0
    Droseph Dang
    May 14, 2021

    Thank you so much!!!!!!! You’re so awesome!!!!!!!!

    0
    benmcgarvey91
    Jan 05

    Hello! Are baseline params the same for the Mars 3?

    0
    4 comments
    transparent logo.png

    302-268-3492

    ​

    ​

    510 Philadelphia Pike
    Wilmington, DE 19809

    © 2007-2020 by AlphaSense, Inc.